Frontier Suri black (ME19A)
 |
 |
The case is a prime example of how a good ATX gaming case doesn't have to be expensive. This is a low-cost and at the same time a well-balanced solution for a gaming platform. The model has an interesting front panel. A metal mesh is installed on the front, decorated with a relief surface. The mesh front allows the standard cooling system to take as much fresh air as necessary to stabilize almost any assembly in terms of power.
The Frontier Suri computer case comes with three pre-installed 120mm fans as standard, and the same number of fans can be installed additionally. Standard coolers are installed on the front panel, and for additional impellers there are several places on top and one at the back. The spectacular appearance of the front panel is complemented by full-fledged RGB lighting, which is built into the standard turntables.
The motherboard seat has fasteners for fixing motherboards of the following sizes: ATX, micro-ATX and mini-ITX. The main sidewall is made of tempered glass — this is a single translucent panel for the entire sidewall, exposing the beauty of the system unit. For greater aesthetics, the lower compartment is covered with a casing, which allows you to discreetly mount the power supply with a pile of wires.
Buy Frontier Suri black
All prices 32 →Frontier Suri ME19A ARGB Tempered Glass без БЖ Black | 1 999 ₴ |  | |||
Корпус Frontier SURI | 1 999 ₴ |  | |||
Корпус Frontier Suri (ME19A) | 1 768 ₴ |  | |||
| 1 768 ₴ |  | ||||
| 1 897 ₴ |  | ||||
1 1 0 2 |
Terrible body No Molex fans (impossible to regulate speed) are very noisy. There is just emptiness between the power supply and the place for the wires, which looks disgusting. The top panel is almost blank, despite the fact that there are holes there. The front dust filter (not even a filter, just a mesh) collects only large debris, so the case is always dusty  Дима: use Frontier Suri more than year |
well, I really don’t know what you can see from the pluses of the song, but it doesn’t scratch and it’s amazingly breathable, but it doesn’t hurt anything breathability, style and slope. everything else is not very good, but not so critical |
Great model for the money
got it for 1600 at a discount I'm pleased to see that there are 3 fans on the front that have an ARGB backlight mode (press and hold the button to change the backlight mode and the ARGB mode will turn on; to remove it, just press the color change button again) but unfortunately, you won’t be able to disconnect one from the front chanter and put it on the back for blowing (the connector doesn’t fit) The case has a beautiful front panel that can be easily removed also 2 dust filters - one on the bottom under the power supply and the second on the top panel The side tempered glass is also nice let's move on to conclusions 1-Appearance
2-3 fans included for the price 3 good airflow The processor temperature in this case (I don’t have a built-in video card) with a Jonesbo Pisa A4 cooler in Aida was about 60-61 degrees at night 55-54 in Genshin at almost maximum temperatures the average temperature is 46 (I added 1 fan to the case for blowing out if necessary) there is room for at least some wiring probably the only drawback is that the place where the power supply is located does not have a side wall, so to speak, that is, you will see the cables that lie there
but if your computer is not on the table, it’s not noticeable |
